Follow these steps to properly install your Tron Tail onto your Sondors Metacyce.
BEFORE THE INSTALL
The Metacycle seat MUST be removed.
Remove the two screws under the seat to remove it.
Remove factory tail light and detach wires. DO NOT discard the factory screws.
You will need to reuse the rear factory screw for the Tron Tail™.
To mount the Tron Tail™, you will essentially pass its wires through the bottom of the Metacycle rear frame.
Then, you will bond the Tron Tail™’s wires to the Metacycle’s.
Mount the Tron Tail™ by reusing the single, rearmost factory screw and the 2 provided black screws and washers that came with your Tron Tail™.
Step 2:
Combine the following wires from the Tron Tail to those of the
Metacycle. [T] stands for Tron Tail™ while [M] stands for Metacycle.
Step 3:
Bond the velcro straps tightly to each other, around the frame's bar.
Access:
Access the interior storage of your MetaRack One effortlessly, while it is mounted.
The more questions are commonly asked, the more prone they are to featuring below.
We'd love to answer your questions with clarity and transparency.
